Difference between revisions of "SDRAM Breakout"

From Hackstrich
Line 2: Line 2:
  
 
== Project Status ==
 
== Project Status ==
 +
* 2015-12-22: Assembled and plugged into the dev board for [[TileDriver]]. Power LED works, but won't really know if the rest of it is working until I get an SDRAM controller designed.
 
* 2015-09-13: Completed silkscreen/CAM/checklisting. Sent to OSH Park for manufacturing.
 
* 2015-09-13: Completed silkscreen/CAM/checklisting. Sent to OSH Park for manufacturing.
 
* 2015-09-12: Needed to connect an SDRAM chip to a MachXO devboard for [[TileDriver]], so started designing this. Schematic is complete, board routing is done and silkscreen is almost done.
 
* 2015-09-12: Needed to connect an SDRAM chip to a MachXO devboard for [[TileDriver]], so started designing this. Schematic is complete, board routing is done and silkscreen is almost done.

Revision as of 16:24, 23 December 2015

I needed to connect an SDRAM chip or two to a devboard and couldn't find a good breakout to do it, so designed this.

Project Status

  • 2015-12-22: Assembled and plugged into the dev board for TileDriver. Power LED works, but won't really know if the rest of it is working until I get an SDRAM controller designed.
  • 2015-09-13: Completed silkscreen/CAM/checklisting. Sent to OSH Park for manufacturing.
  • 2015-09-12: Needed to connect an SDRAM chip to a MachXO devboard for TileDriver, so started designing this. Schematic is complete, board routing is done and silkscreen is almost done.

Overview

  • One SDRAM chip footprint for a 16-bit wide chip
  • Pins to connect to LCMXO2280C-B-EVN devboard (or wires to connect to anything else)
  • Test points to attach a scope for troubleshooting