Difference between revisions of "Project Dandelion/Work Log"
From Hackstrich
| Line 7: | Line 7: | ||
* Did a lot of wiring harness tracing, added to schematic. Removed any wiring that could be removed once it was traced/documented. Took photos of all wire routing (not yet uploaded) so that I can hopefully re-route it the same once it goes back in. | * Did a lot of wiring harness tracing, added to schematic. Removed any wiring that could be removed once it was traced/documented. Took photos of all wire routing (not yet uploaded) so that I can hopefully re-route it the same once it goes back in. | ||
* Removed maintenance panel board for reverse-engineering. | * Removed maintenance panel board for reverse-engineering. | ||
| + | |||
| + | == 2015-05-23 == | ||
| + | * Started a separate log for this - [http://dandelion.sen.cx sen's Xerox Star 8010 Restoration Log] | ||
[[Category:Project Dandelion]] | [[Category:Project Dandelion]] | ||
Latest revision as of 01:02, 24 May 2015
2010-04-02
- Photographed whole chassis before removing/disconnecting any parts. Cleaned out all loose paper/foam/etc. Started identifying major components and what the purpose of each is. Photos available in Initial Internal Photos gallery.
- Removed and wirebrushed card cage fan retention bracket.
- Reverse engineered a schematic for the power distribution board and created an EAGLE schematic for it.
2010-04-04
- Did a lot of wiring harness tracing, added to schematic. Removed any wiring that could be removed once it was traced/documented. Took photos of all wire routing (not yet uploaded) so that I can hopefully re-route it the same once it goes back in.
- Removed maintenance panel board for reverse-engineering.
2015-05-23
- Started a separate log for this - sen's Xerox Star 8010 Restoration Log
