Difference between revisions of "LaserBox/Mux Board"

From Hackstrich
(First board is built, no issues so far.)
Line 8: Line 8:
 
* 2017-01-29: Have been working on schematic and board, schematic/BOM are done, board is 95% done routing.
 
* 2017-01-29: Have been working on schematic and board, schematic/BOM are done, board is 95% done routing.
 
* 2017-01-21: Started putting together electronics design.
 
* 2017-01-21: Started putting together electronics design.
 +
 +
== Rev001 Issues ==
 +
* Connectors provide a GND pin for each I/O pin, but the I/Os are sinks! Need +5V and I/O really.
 +
** Too late to re-spin the board, the connectors do provide one +5V pin so I'll have to work around the bug with creative cable building.
  
 
[[Category:Current Projects]]
 
[[Category:Current Projects]]

Revision as of 23:26, 24 March 2017

The LaserBox Mux Board controls 36 lasers off three I/O pins, using shift registers. It has 6 separate channel connectors, each with 8 output pins on it.

Project Status

  • 2017-03-18: Boards arrived, built the first one and so far seems to be working with no issues. Have only tested with LEDs, once lasers are tested I'll call this complete.
  • 2017-03-03: Completed checklisting, board sent to OSH Park w/ expedited shipping option, should have them a couple weeks.
  • 2017-02-28: Submission accepted, will do final review of board and get it sent off for ASAP manufacturing tonight or tomorrow.
  • 2017-01-30: Completed schematic/BOM/board layout.
  • 2017-01-29: Have been working on schematic and board, schematic/BOM are done, board is 95% done routing.
  • 2017-01-21: Started putting together electronics design.

Rev001 Issues

  • Connectors provide a GND pin for each I/O pin, but the I/Os are sinks! Need +5V and I/O really.
    • Too late to re-spin the board, the connectors do provide one +5V pin so I'll have to work around the bug with creative cable building.