Difference between revisions of "HackTrack Shield"
From Hackstrich
(Initial page for the HackTrack Shield) |
m (Fixing link...) |
||
| (6 intermediate revisions by the same user not shown) | |||
| Line 13: | Line 13: | ||
== Project Status == | == Project Status == | ||
| − | Revision 1 boards and parts ordered 2011-03-13. | + | Revision 1 boards and parts ordered 2011-03-13. Board built and working (but see revision 1 notes below) with HackTrack. The [[IOstrich]] Strich Labs product supersedes this board, dropping the LCD connection but keeping the GPIO expansion. |
| − | [[Category: | + | == Revision 1 Notes == |
| + | * Shroud on LCD connector interferes with Backlight On jumper and Direct/I2C jumpers | ||
| + | * Each female GPIO connector plugged into the male ones on the board interfere with each other | ||
| + | * Almost every connector interferes with every other one | ||
| + | * Pin 5 on the LCD needs to be tied low | ||
| + | |||
| + | [[Category:Completed Projects]] | ||
[[Category:Arduino Shields]] | [[Category:Arduino Shields]] | ||
[[Category:Products]] | [[Category:Products]] | ||
| − | |||
Latest revision as of 03:45, 23 September 2011
| 200px | |
| This Page | |
| Function: | Provide 40 GPIOs and an LCD port, accessible via I2C. |
|---|---|
| Key Chips: | NXP PCA9505 |
| External Ports: | 1x HD4480 LCD, 40x GPIO |
| Required Pins: | A4 (I2C SDA), A5 (I2C SCL) |
| Optional Pins: | D2, D3 (Interrupts/LCD), D5-D9 (LCD) |
The HackTrack shield will provide 40 GPIOs and a port for an LCD, for use in the HackTrack project initially.
Project Status
Revision 1 boards and parts ordered 2011-03-13. Board built and working (but see revision 1 notes below) with HackTrack. The IOstrich Strich Labs product supersedes this board, dropping the LCD connection but keeping the GPIO expansion.
Revision 1 Notes
- Shroud on LCD connector interferes with Backlight On jumper and Direct/I2C jumpers
- Each female GPIO connector plugged into the male ones on the board interfere with each other
- Almost every connector interferes with every other one
- Pin 5 on the LCD needs to be tied low
