Difference between revisions of "Huxley"
From Hackstrich
(Parts list for the extruder's cold end.) |
(Status update.) |
||
| Line 6: | Line 6: | ||
= Status = | = Status = | ||
| + | * 2011-12-05: Printed the fixed block with no issues. Started putting together parts lists. | ||
* 2011-12-04: Printed all components for the extruder other than the fixed block. The duct-1 component failed 95% through the print, I think it should be okay as-is, but if not a separate extension piece could probably be added. Decided on Sanguinololu electronics, ordered 1x NEMA11 stepper, 3x NEMA14 steppers, and Pololu stepper drivers from Pololu. Still need to order Sanguinololu itself. | * 2011-12-04: Printed all components for the extruder other than the fixed block. The duct-1 component failed 95% through the print, I think it should be okay as-is, but if not a separate extension piece could probably be added. Decided on Sanguinololu electronics, ordered 1x NEMA11 stepper, 3x NEMA14 steppers, and Pololu stepper drivers from Pololu. Still need to order Sanguinololu itself. | ||
Revision as of 14:13, 6 December 2011
I'm building a RepRap Huxley, printing parts on the HackLab's Makerbot.
Components
- Extruder/Hot End: Universal Mini Extruder modified for bowden cable
- Electronics: Sanguinololu
Status
- 2011-12-05: Printed the fixed block with no issues. Started putting together parts lists.
- 2011-12-04: Printed all components for the extruder other than the fixed block. The duct-1 component failed 95% through the print, I think it should be okay as-is, but if not a separate extension piece could probably be added. Decided on Sanguinololu electronics, ordered 1x NEMA11 stepper, 3x NEMA14 steppers, and Pololu stepper drivers from Pololu. Still need to order Sanguinololu itself.
Parts Lists
Extruder Cold End
| Part | Qty Req'd | Supplier | Status |
|---|---|---|---|
| M3 washers | 13 | ||
| M4 washers | 2 | ||
| M6 washer | 1 | ||
| M3 nut | 33 | ||
| M4 nut | 1 | ||
| M6 wing nut | 2 | ||
| 12mm M2.5 screws | 4 | ||
| 30mm M3 cap screw | 1 | ||
| 10mm M3 grub/set screw | 1 | ||
| 15mm M4 cap screws | 2 | ||
| 80mm M6 bolt | 1 | ||
| M3 threaded rod 40mm long | 1 | ||
| M3 threaded rod 55mm long | 4 | ||
| M3 threaded rod 80mm long | 2 | ||
| Wire spring - 1mm wire, 4mm ID, 12mm long | 1 | ||
| 626 bearing (6x19x6) | 2 | ||
| 623 bearing (3x10x4) | 1 |
