Difference between revisions of "SDRAM Breakout"
From Hackstrich
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| + | * 2015-12-22: Assembled and plugged into the dev board for [[TileDriver]]. Power LED works, but won't really know if the rest of it is working until I get an SDRAM controller designed. | ||
* 2015-09-13: Completed silkscreen/CAM/checklisting. Sent to OSH Park for manufacturing. | * 2015-09-13: Completed silkscreen/CAM/checklisting. Sent to OSH Park for manufacturing. | ||
* 2015-09-12: Needed to connect an SDRAM chip to a MachXO devboard for [[TileDriver]], so started designing this. Schematic is complete, board routing is done and silkscreen is almost done. | * 2015-09-12: Needed to connect an SDRAM chip to a MachXO devboard for [[TileDriver]], so started designing this. Schematic is complete, board routing is done and silkscreen is almost done. | ||
Revision as of 16:24, 23 December 2015
I needed to connect an SDRAM chip or two to a devboard and couldn't find a good breakout to do it, so designed this.
Project Status
- 2015-12-22: Assembled and plugged into the dev board for TileDriver. Power LED works, but won't really know if the rest of it is working until I get an SDRAM controller designed.
- 2015-09-13: Completed silkscreen/CAM/checklisting. Sent to OSH Park for manufacturing.
- 2015-09-12: Needed to connect an SDRAM chip to a MachXO devboard for TileDriver, so started designing this. Schematic is complete, board routing is done and silkscreen is almost done.
Overview
- One SDRAM chip footprint for a 16-bit wide chip
- Pins to connect to LCMXO2280C-B-EVN devboard (or wires to connect to anything else)
- Test points to attach a scope for troubleshooting
