Difference between revisions of "SDRAM Breakout"
From Hackstrich
(Created page with "I needed to connect an SDRAM chip or two to a devboard and couldn't find a good breakout to do it, so designed this. == Project Status == * 2015-09-12: Needed to connect a coupl...") |
(Almost done.) |
||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| − | * 2015-09-12: Needed to connect a couple SDRAM chips to a MachXO devboard for [[TileDriver]], so started designing this. | + | * 2015-09-12: Needed to connect a couple SDRAM chips to a MachXO devboard for [[TileDriver]], so started designing this. Schematic is complete, board routing is done and silkscreen is almost done. |
== Overview == | == Overview == | ||
| − | * One | + | * One SDRAM chip footprint for a 16-bit wide chip |
* Pins to connect to LCMXO2280C-B-EVN devboard (or wires to connect to anything else) | * Pins to connect to LCMXO2280C-B-EVN devboard (or wires to connect to anything else) | ||
* Test points to attach a scope for troubleshooting | * Test points to attach a scope for troubleshooting | ||
[[Category:Current Projects]] | [[Category:Current Projects]] | ||
Revision as of 04:47, 13 September 2015
I needed to connect an SDRAM chip or two to a devboard and couldn't find a good breakout to do it, so designed this.
Project Status
- 2015-09-12: Needed to connect a couple SDRAM chips to a MachXO devboard for TileDriver, so started designing this. Schematic is complete, board routing is done and silkscreen is almost done.
Overview
- One SDRAM chip footprint for a 16-bit wide chip
- Pins to connect to LCMXO2280C-B-EVN devboard (or wires to connect to anything else)
- Test points to attach a scope for troubleshooting
