Difference between revisions of "Project Dandelion/Work Log"

Latest revision as of 01:02, 24 May 2015

Photographed whole chassis before removing/disconnecting any parts. Cleaned out all loose paper/foam/etc. Started identifying major components and what the purpose of each is. Photos available in Initial Internal Photos gallery.
Removed and wirebrushed card cage fan retention bracket.
Reverse engineered a schematic for the power distribution board and created an EAGLE schematic for it.

Did a lot of wiring harness tracing, added to schematic. Removed any wiring that could be removed once it was traced/documented. Took photos of all wire routing (not yet uploaded) so that I can hopefully re-route it the same once it goes back in.
Removed maintenance panel board for reverse-engineering.

@@ Line 1: / Line 1: @@
-<b>2010-04-02</b>: Photographed whole chassis before removing/disconnecting any parts.  Cleaned out all loose paper/foam/etc.  Started identifying major components and what the purpose of each is.
+== 2010-04-02 ==
+* Photographed whole chassis before removing/disconnecting any parts.  Cleaned out all loose paper/foam/etc.  Started identifying major components and what the purpose of each is.  Photos available in [http://sarahemm.net/gallery/v/projects/dandelion/initial_internal/ Initial Internal Photos gallery].
+* Removed and wirebrushed card cage fan retention bracket.
+* Reverse engineered a schematic for the power distribution board and created an EAGLE schematic for it.
+== 2010-04-04 ==
+* Did a lot of wiring harness tracing, added to schematic.  Removed any wiring that could be removed once it was traced/documented.  Took photos of all wire routing (not yet uploaded) so that I can hopefully re-route it the same once it goes back in.
+* Removed maintenance panel board for reverse-engineering.
+== 2015-05-23 ==
+* Started a separate log for this - [http://dandelion.sen.cx sen's Xerox Star 8010 Restoration Log]
 [[Category:Project Dandelion]]