Difference between revisions of "StrichLux/PWR-DC5"
From Hackstrich
m (BOM put together.) |
(Status update.) |
||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| + | * 2012-05-22: Completed schematic, initial component placement on PCB done. | ||
* 2012-05-20: Put BOM together. | * 2012-05-20: Put BOM together. | ||
* 2012-05-01: Started initial design. | * 2012-05-01: Started initial design. | ||
| Line 11: | Line 12: | ||
[[Category:Current Projects]] | [[Category:Current Projects]] | ||
| − | [[Category:Status/ | + | [[Category:Status/Laying out Board]] |
Revision as of 04:24, 22 May 2012
The StrichLux PWR-DC5 module will take a DC input (5 or 12V) and output 5VDC @ 20A out on each high-power bus (total of 40A/200W).
Project Status
- 2012-05-22: Completed schematic, initial component placement on PCB done.
- 2012-05-20: Put BOM together.
- 2012-05-01: Started initial design.
Specs
- At least 4.5-13.8V input (will depend on the DC-DCs used)
- 200W / 20A output per bus
- Most likely candidate for the DC-DC converters is the Lineage UVT020A0X3-SRZ
