Difference between revisions of "Playameter"
From Hackstrich
(Issue log) |
|||
| Line 7: | Line 7: | ||
* 2012-01-02: LCD we chose was discontinued. Swapped it for a new one, as well as added an expansion connector and changed L1 to a smaller size. Component placement pretty much done, routing started. | * 2012-01-02: LCD we chose was discontinued. Swapped it for a new one, as well as added an expansion connector and changed L1 to a smaller size. Component placement pretty much done, routing started. | ||
* Pre-2012: Lisa did the schematic capture and initial component placement. | * Pre-2012: Lisa did the schematic capture and initial component placement. | ||
| + | |||
| + | = Revision 1 Issues = | ||
| + | * +5 pin on ICSP header not connected | ||
| + | * Wrong power jack on BOM (2-pin rather than 3-pin) | ||
[[Category:Current Projects]] | [[Category:Current Projects]] | ||
Revision as of 16:33, 6 April 2012
Playameter is a joint project between Lisa and myself to create a weather station designed for use at Burning Man.
Project Status
- 2012-02: Parts arrived, board stuffed. Found that wrong power jacks and package for solar charger IC were ordered, waiting on the correct ones now.
- 2012-01: PCB design completed and sent off.
- 2012-01-03: Routing complete, but checklists haven't been run through (other than erc/drc passing) and silkscreen hasn't been added. Sent a pull request to Lisa to merge this back in, which she did. Back to her for the rest of the board tasks!
- 2012-01-02: LCD we chose was discontinued. Swapped it for a new one, as well as added an expansion connector and changed L1 to a smaller size. Component placement pretty much done, routing started.
- Pre-2012: Lisa did the schematic capture and initial component placement.
Revision 1 Issues
- +5 pin on ICSP header not connected
- Wrong power jack on BOM (2-pin rather than 3-pin)
