Difference between revisions of "Solder Paste Dispenser"

From Hackstrich
m (WFT.)
(Status update. Almost done!)
Line 2: Line 2:
  
 
== Project Status ==
 
== Project Status ==
 +
* 2012-03-21: Eric sealed the vacuum hose properly, and got a foot pedal connected.  Need to bring syringes and misc. parts I have at home next time I'm at the lab to finish this!
 
* 2011-10-08: Norman has put the new air connector on.  I have put a temporary plug into the vacuum connector and tested the unit, it seems to work fine (though currently leaks air out of every connection).
 
* 2011-10-08: Norman has put the new air connector on.  I have put a temporary plug into the vacuum connector and tested the unit, it seems to work fine (though currently leaks air out of every connection).
 
* 2011-07-18: Worked on this with Norman at the lab, he is arranging a new air connector for it, I will sort out what to do about the missing vacuum needle valve.
 
* 2011-07-18: Worked on this with Norman at the lab, he is arranging a new air connector for it, I will sort out what to do about the missing vacuum needle valve.

Revision as of 17:24, 23 March 2012

The Solder Paste Dispenser project's aim is to assemble a device that can be used to easily apply solder paste to boards using minimal manual effort.

Project Status

  • 2012-03-21: Eric sealed the vacuum hose properly, and got a foot pedal connected. Need to bring syringes and misc. parts I have at home next time I'm at the lab to finish this!
  • 2011-10-08: Norman has put the new air connector on. I have put a temporary plug into the vacuum connector and tested the unit, it seems to work fine (though currently leaks air out of every connection).
  • 2011-07-18: Worked on this with Norman at the lab, he is arranging a new air connector for it, I will sort out what to do about the missing vacuum needle valve.
  • Pre-2011: Parts have arrived, new power input module and fuse holder received and need to be installed/tested. Electronics tested and working fine, air circuit not yet tested due to incompatible connectors.

Goals/Requirements

  • Operate independently of a shop air source
  • Dispense using a foot pedal or finger switch
  • Have minimal parts so it can be stored in a small bin at the lab

System Plan

  • Small (1/4 gallon) air tank, can charge using a schraeder valve from a tire pump
  • EFD 2000XL dispenser controller