Difference between revisions of "PoE Shield"

From Hackstrich
(Parts here, assembly started.)
(A couple issues resolved.)
Line 7: Line 7:
  
 
=== Notes from Rev. 1 ===
 
=== Notes from Rev. 1 ===
* For LM5070 library part put a notation for where pin 1 goes.
+
* Package has silkscreen already, just none on bottom of rev. 1 boards: </s>For LM5070 library part put a notation for where pin 1 goes.</s>
* C6 footprint does not match BoM (C6 should be 0603 or footprint to 0805)
+
* Fixed in revision 2: <s>C6 footprint does not match BoM (C6 should be 0603 or footprint to 1210)</s>
 
* D2 has no silkscreen
 
* D2 has no silkscreen
 
* Fix footprint on U2 (Pads are too far apart lengthwise)
 
* Fix footprint on U2 (Pads are too far apart lengthwise)

Revision as of 14:28, 21 November 2010

The PoE shield will be compatible software-wise with the official Arduino Ethernet Shield, but also supply power to the board via Power over Ethernet.

Project Status

Design, BOM, schematic, and PCB layout complete, PCBs and parts received, revision 1 board assembly is in progress.

Notes

Notes from Rev. 1

  • Package has silkscreen already, just none on bottom of rev. 1 boards: For LM5070 library part put a notation for where pin 1 goes.
  • Fixed in revision 2: C6 footprint does not match BoM (C6 should be 0603 or footprint to 1210)
  • D2 has no silkscreen
  • Fix footprint on U2 (Pads are too far apart lengthwise)
  • Fix footprint for U3 (it's just generally wrong)

Ideas for Rev. 2

  • Could switch the main transformer to a POE13W3VERS-R (1.8/3.3/7V) or 7491192912 (3.3/5/12V) to avoid the need for secondary regulation all together