Playameter

From Hackstrich
Revision as of 05:08, 9 September 2012 by SarahEmm (talk | contribs) (Dormantizing for now.)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Playameter is a joint project between Lisa and myself to create a weather station designed for use at Burning Man.

Project Status

  • 2012-09-09: Dormant until I have more time to work on this with Lisa, hopefully before BM2013.
  • 2012-04-23: Assembled charging section and GPS, haven't tested yet.
  • 2012-04-06: Assembled new power jacks and LCD backlight resistors, wrote test code and proved microcontroller and LCD are working fine.
  • 2012-02: Parts arrived, board stuffed. Found that wrong power jacks and package for solar charger IC were ordered, waiting on the correct ones now.
  • 2012-01: PCB design completed and sent off.
  • 2012-01-03: Routing complete, but checklists haven't been run through (other than erc/drc passing) and silkscreen hasn't been added. Sent a pull request to Lisa to merge this back in, which she did. Back to her for the rest of the board tasks!
  • 2012-01-02: LCD we chose was discontinued. Swapped it for a new one, as well as added an expansion connector and changed L1 to a smaller size. Component placement pretty much done, routing started.
  • Pre-2012: Lisa did the schematic capture and initial component placement.

Revision 1 Issues

  • +5 pin on ICSP header not connected
  • Wrong power jack on BOM (2-pin rather than 3-pin)
  • PSB pin on LCD needs to be grounded, not floating