Difference between revisions of "HackLab.TO Timing Reference A"

From Hackstrich
Line 20: Line 20:
  
 
== GPS Module Status ==
 
== GPS Module Status ==
 +
* 2013-11: Received and assembled, GPS communication works but GPS never locks. Need to troubleshoot this further, could be a setup issue, bad GPS board, or an issue with the RF pass-through.
 
* 2013-10-14: Main board sent to OSH Park for prototype. Display board will be done later.
 
* 2013-10-14: Main board sent to OSH Park for prototype. Display board will be done later.
 
* 2013-05-16: Main board checklisted, ready for CAM. Display board schematicized, routed. Needs to have mechanical design done and be checklisted.
 
* 2013-05-16: Main board checklisted, ready for CAM. Display board schematicized, routed. Needs to have mechanical design done and be checklisted.

Revision as of 06:14, 1 January 2014

This is the main timing reference for HackLab.TO (and tick.hacklab.to).

Project Overview

  • Built into an American Data 800-series chassis (3U, 10 modules each with line voltage on an edge connector + space for a connector to the back panel)
  • Chassis came with 10 AD805 distribution amplifiers (1 BNC in, 1 daisychain out, 6 amplified outputs)
    • Will replace as many as required with other timing-related modules, remaining ones will be used to distribute timing references around

GPS Module

  • Will take up 2 slots
  • Motorola OnCore UT timing receiver
  • 7-segment LED displays for:
    • UTC Time (6 digits, red)
    • Number of SVs in view (2 digits, green)
  • LEDs
    • Power (green)
    • Comms (white)
    • GPS Fix (blue)
    • Replace Battery (yellow)
    • Fault (red)

GPS Module Status

  • 2013-11: Received and assembled, GPS communication works but GPS never locks. Need to troubleshoot this further, could be a setup issue, bad GPS board, or an issue with the RF pass-through.
  • 2013-10-14: Main board sent to OSH Park for prototype. Display board will be done later.
  • 2013-05-16: Main board checklisted, ready for CAM. Display board schematicized, routed. Needs to have mechanical design done and be checklisted.
  • 2013-05-15: Main board completely laid out, just needs checklist run.
  • 2013-05-13: Chassis is here now and has no PSU, just line voltage going to the cards. Redesigned the module to have a main board (which has the AC/DC converter and most logic on it) and a display board (which has the LED driver and displays on it, and goes on the front panel). Main board is schematicized and 50% laid out now.
  • 2013-Early: Designed the module to go on the back of the front panel.