Difference between revisions of "Arduibug"

From Hackstrich
m (Recategorizing to Dormant until I get more time to work on this.)
 
(7 intermediate revisions by the same user not shown)
Line 2: Line 2:
  
 
== Project Status ==
 
== Project Status ==
PCB design complete, initial physical validation looks good.  BOM on file at Digikey, just need to order prototype boards and parts now.
+
* 2012-12: Newer Arduinos make this much easier (via a solder jumper).  Cancelling the project as it's not needed anymore!
 +
* PCB design complete, initial physical validation looks good.  BOM on file at Digikey, boards ordered and received from @laen.  Parts ordered and received from Mouser.
  
[[Category:Dormant Projects]]
+
[[Category:Cancelled Projects]]

Latest revision as of 04:56, 26 December 2012

The Arduibug is a small adapter board that 'wedges in' between the chip and the socket on the Arduino Diecimila or Duemilanove and allows use of a Debugwire in-circuit-debugger. The normal Arduino board does not allow this due to other components on the /RST line. The board is completely passive, the only components are sockets/headers/switches.

Project Status

  • 2012-12: Newer Arduinos make this much easier (via a solder jumper). Cancelling the project as it's not needed anymore!
  • PCB design complete, initial physical validation looks good. BOM on file at Digikey, boards ordered and received from @laen. Parts ordered and received from Mouser.