Solder Paste Dispenser
From Hackstrich
The Solder Paste Dispenser project's aim is to assemble a device that can be used to easily apply solder paste to boards using minimal manual effort.
Project Status
Parts have arrived, new power input module and fuse holder received and need to be installed/tested.
Goals/Requirements
- Operate independently of a shop air source
- Dispense using a foot pedal or finger switch
- Have minimal parts so it can be stored in a small bin at the lab
System Plan
- Small (1/4 gallon) air tank, can charge using a schraeder valve from a tire pump
- EFD 2000XL dispenser controller
