Difference between revisions of "StrichLux/IO-ETH"
From Hackstrich
(Status update) |
(LED display issue.) |
||
| Line 19: | Line 19: | ||
* Ethernet termination resistors are shown as 75 on the schematic, but (correctly) 49.9 on BOM | * Ethernet termination resistors are shown as 75 on the schematic, but (correctly) 49.9 on BOM | ||
* C5 is under the crystal! | * C5 is under the crystal! | ||
| + | * LED display common wired to GND, but it's a common anode unit | ||
[[Category:Current Projects]] | [[Category:Current Projects]] | ||
[[Category:Status/Waiting for Time]] | [[Category:Status/Waiting for Time]] | ||
Revision as of 00:46, 23 June 2012
The StrichLux IO-ETH module will provide 1-4 universes of input or output via Art-Net initially, but may support other protocols later. This module can "take over" adjacent channels if configured to, so that only one module is needed for a complete StrichLux system.
Project Status
- 2012-06-21: PCBs and parts are here, assembled the first board. No time to test, will have to do that tomorrow. Firmware is ~10% complete.
- 2012-05-27: Routing done, checklist run, CAM processing done, sent off to MyRO for PCB manufacturing. Still need to order parts.
- 2012-05-26: Schematic/BOM complete, routing starting.
- 2012-05-25: Started schematic.
- 2012-05-01: Renamed from IO-ArtNet to IO-ETH, as I may support ACN or other protocols later.
- 2012-04-24: Started initial planning.
Specs
- Based around the PIC32MX664F128H microcontroller as there is no economical way to do Ethernet on FPGAs for low-cost designs
- This micro has no EEPROM (?!) so will need external I2C EEPROM for storing config data
- Using one with a MAC address burns in solves the problem of needing an IAB too
- Also needs external PHY
- LAN8720C is supported, small, and inexpensive, so it seems a good choice
Rev. 1 Issues
- Ethernet termination resistors are shown as 75 on the schematic, but (correctly) 49.9 on BOM
- C5 is under the crystal!
- LED display common wired to GND, but it's a common anode unit
