Difference between revisions of "BrailleNote Tieman Display"
From Hackstrich
(Few other notes from tonight.) |
(Voltages adding.) |
||
| Line 4: | Line 4: | ||
* Pinout of display connector (from edge of board opposite SMD cap) | * Pinout of display connector (from edge of board opposite SMD cap) | ||
** Left Side (male) | ** Left Side (male) | ||
| − | *** Red - HV | + | *** Red - HV (~250V) |
*** Grey - Ground | *** Grey - Ground | ||
*** Grey - Data B | *** Grey - Data B | ||
| Line 10: | Line 10: | ||
*** Green - CLK | *** Green - CLK | ||
*** Grey - !LatchEnable | *** Grey - !LatchEnable | ||
| − | *** Grey - LV | + | *** Grey - LV (~5VDC) |
*** Grey - Direction (Low = A in, B out) | *** Grey - Direction (Low = A in, B out) | ||
** Right Side (female) | ** Right Side (female) | ||
| − | *** Red - HV | + | *** Red - HV (~250VDC) |
*** Grey - Ground | *** Grey - Ground | ||
*** Grey - Data A | *** Grey - Data A | ||
| Line 19: | Line 19: | ||
*** Green - CLK | *** Green - CLK | ||
*** Grey - !LatchEnable | *** Grey - !LatchEnable | ||
| − | *** Grey - LV | + | *** Grey - LV (~5VDC) |
*** Grey - Direction (Low = A in, B out) | *** Grey - Direction (Low = A in, B out) | ||
** Data pin is connected to straight-through pin on the last backplane board, which lets the BN read the bits back to ensure the display is working | ** Data pin is connected to straight-through pin on the last backplane board, which lets the BN read the bits back to ensure the display is working | ||
Revision as of 04:18, 20 December 2011
- Display uses 1 "backplane board" per 8 cells
- Each backplane board has 8 cell connectors, 2 inter-board connectors (left and right), and one Supertex HV507PG chip
- The HV507PG is a high-voltage 64 channel shift register
- Pinout of display connector (from edge of board opposite SMD cap)
- Left Side (male)
- Red - HV (~250V)
- Grey - Ground
- Grey - Data B
- Grey - Straight through to right side
- Green - CLK
- Grey - !LatchEnable
- Grey - LV (~5VDC)
- Grey - Direction (Low = A in, B out)
- Right Side (female)
- Red - HV (~250VDC)
- Grey - Ground
- Grey - Data A
- Grey - Straight through to left side
- Green - CLK
- Grey - !LatchEnable
- Grey - LV (~5VDC)
- Grey - Direction (Low = A in, B out)
- Data pin is connected to straight-through pin on the last backplane board, which lets the BN read the bits back to ensure the display is working
- Left Side (male)
