Difference between revisions of "EL Driver Shield"
From Hackstrich
m (Removing the ? beside 8 channels. It will be/is 8.) |
(Updating with today's status.) |
||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| + | * 2011-10-06: Completed board routing, still need to do silkscreen and checklist. | ||
* 2011-10-05: Completed revision 1 schematic, passes checklist. Started board layout, got about 50% complete. | * 2011-10-05: Completed revision 1 schematic, passes checklist. Started board layout, got about 50% complete. | ||
* 2011-10-04: Almost finished HV AC switching/control. | * 2011-10-04: Almost finished HV AC switching/control. | ||
Revision as of 04:29, 7 October 2011
The EL Driver Shield will drive 8 channels of EL wire, generating required voltages on the shield itself. Each channel will support dimming individually.
Project Status
- 2011-10-06: Completed board routing, still need to do silkscreen and checklist.
- 2011-10-05: Completed revision 1 schematic, passes checklist. Started board layout, got about 50% complete.
- 2011-10-04: Almost finished HV AC switching/control.
- 2011-10-03: Finished BOM/schematic for HV AC converter/inverter.
- 2011-10-02: Finished designing/simulating HV DC generator in LTSpice, put BOM and schematic for this section together.
- 2011-10-01: Many hours spent in LTSpice putting together a design for the HV DC generation.
- 2011-09-30: Started putting basic design ideas together.
Ideas / Brainstorming
- One single high voltage converter with separate switches for each channel
- Dimming using PWM via optoTRIAC on each channel, synced with the HV AC converter
- Shield will likely need a microcontroller on it
- Inputs: 2x I2C address setting
- Outputs: 1x HV DC converter sync pulse, 1x HV AC converter polarity signal, 8x optoTRIAC gate outputs
- Bus: I2C, RS232
