Difference between revisions of "EL Driver Shield"
From Hackstrich
(Added an inverter so that only one pin on the micro is needed to control the HVAC inverter.) |
(Done rev. 1 schematic.) |
||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| − | * 2011-10- | + | * 2011-10-05: Completed revision 1 schematic, passes checklist. Board layout is next! |
| + | * 2011-10-04: Almost finished HV AC switching/control. | ||
| + | * 2011-10-03: Finished BOM/schematic for HV AC converter/inverter. | ||
* 2011-10-02: Finished designing/simulating HV DC generator in LTSpice, put BOM and schematic for this section together. | * 2011-10-02: Finished designing/simulating HV DC generator in LTSpice, put BOM and schematic for this section together. | ||
* 2011-10-01: Many hours spent in LTSpice putting together a design for the HV DC generation. | * 2011-10-01: Many hours spent in LTSpice putting together a design for the HV DC generation. | ||
Revision as of 15:27, 5 October 2011
The EL Driver Shield will drive 8(?) channels of EL wire, generating required voltages on the shield itself. Each channel will support dimming individually.
Project Status
- 2011-10-05: Completed revision 1 schematic, passes checklist. Board layout is next!
- 2011-10-04: Almost finished HV AC switching/control.
- 2011-10-03: Finished BOM/schematic for HV AC converter/inverter.
- 2011-10-02: Finished designing/simulating HV DC generator in LTSpice, put BOM and schematic for this section together.
- 2011-10-01: Many hours spent in LTSpice putting together a design for the HV DC generation.
- 2011-09-30: Started putting basic design ideas together.
Ideas / Brainstorming
- One single high voltage converter with separate switches for each channel
- Dimming using a TRIAC on each channel like incandescent lights use
- Shield will likely need a microcontroller on it
- Inputs:
- Outputs: 1x HV DC converter sync pulse, 1x HV AC converter sync/polarity flip pulse, 8x optoTRIAC gate outputs
- Bus: I2C
