Difference between revisions of "RGB Matrix Backpack"
From Hackstrich
(Some parts received.) |
(Issues with rev. 1 found.) |
||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| − | + | Revision 1 board assembled, troubleshooting and writing code now. | |
== Rough Notes == | == Rough Notes == | ||
| Line 12: | Line 12: | ||
* Being able to plug them together in a 2D matrix would be awesome | * Being able to plug them together in a 2D matrix would be awesome | ||
* They plug into a 1D matrix natively, and there's a cable interface to link multiple 1D rows together into a 2D display | * They plug into a 1D matrix natively, and there's a cable interface to link multiple 1D rows together into a 2D display | ||
| + | |||
| + | == Revision 1 Notes == | ||
| + | * Silkscreen on inter-board connectors is incorrect on some | ||
| + | * Constant current regulator not implemented properly, output should be on the far side of the current sense resistor, not the near side | ||
[[Category:Current Projects]] | [[Category:Current Projects]] | ||
[[Category:Status/Waiting for Parts]] | [[Category:Status/Waiting for Parts]] | ||
Revision as of 21:22, 3 January 2011
The RGB Matrix Backpack will be a small controller board to attach to 8x8 RGB LED matrices. It will accept input via SPI or I2C and control the display.
Project Status
Revision 1 board assembled, troubleshooting and writing code now.
Rough Notes
- Going to use the PIC18F65K22 as it will drive all the pins needed directly (no muxes or anything) and is <$5 in single qty. Cheaper than using multiplexers and more flexible this way.
- Also I haven't used PICs in any projects in ~5 years, so I want to try them out again :)
- Cathode/low side (columns) will be N-channel MOSFETs.
- Which is nice because there are 24 columns to drive, but only 8 rows. Cheaper components on the columns is handy.
- Anode/high side (rows) should be a constant current source with P-channel MOSFETs.
- Being able to plug them together in a 2D matrix would be awesome
- They plug into a 1D matrix natively, and there's a cable interface to link multiple 1D rows together into a 2D display
Revision 1 Notes
- Silkscreen on inter-board connectors is incorrect on some
- Constant current regulator not implemented properly, output should be on the far side of the current sense resistor, not the near side
