Difference between revisions of "CPLD Intro Board"
From Hackstrich
(Created page with "I can't find a good Lattice-based intro board for CPLD stuff that has good I/O, a programmer, and is cheap, so I'm designing one instead. == Project Status == * 2014-12-29: Star...") |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| − | * 2014-12-29: Started putting idea together. | + | * 2014-12-29: Started putting idea together. Started BOM and schematic, 90% done at this point. Still need to pin out iobank1 and add test points, also add bypass caps to BOM. |
== Specs == | == Specs == | ||
| Line 10: | Line 10: | ||
* 8x LEDs | * 8x LEDs | ||
* 1x 7-segment LED display | * 1x 7-segment LED display | ||
| − | |||
* USB JTAG via FT2232 (channel A) | * USB JTAG via FT2232 (channel A) | ||
** USB serial via same FT2232 (channel B) | ** USB serial via same FT2232 (channel B) | ||
| Line 18: | Line 17: | ||
*** Would be 3.3v-only though, so of limited use | *** Would be 3.3v-only though, so of limited use | ||
| − | [[Category: | + | [[Category:Dormant Projects]] |
Latest revision as of 14:23, 24 April 2015
I can't find a good Lattice-based intro board for CPLD stuff that has good I/O, a programmer, and is cheap, so I'm designing one instead.
Project Status
- 2014-12-29: Started putting idea together. Started BOM and schematic, 90% done at this point. Still need to pin out iobank1 and add test points, also add bypass caps to BOM.
Specs
- MachXO CPLD LCMXO256C-3TN100C
- 8x slide switches
- 8x pushbuttons
- 8x LEDs
- 1x 7-segment LED display
- USB JTAG via FT2232 (channel A)
- USB serial via same FT2232 (channel B)
- All pins also on expansion connectors
- Onboard peripherals disablable via solder jumpers or something?
- Possibly also Arduino shield connector footprints to use it as a shield?
- Would be 3.3v-only though, so of limited use
