Difference between revisions of "Zappy Module"

Revision as of 05:28, 8 March 2015

Zappy Module is a board-level module that takes control input via some kind of protocol and outputs signals to zap someone like shock collars do.

Control input options could be:
- GPIO-based, simple "zap now" input (or a couple separate inputs that you can set with different options)
- I2C/SPI/RS232
  - Could be used for instant control or programming levels/durations for later GPIO-based activation

Input voltage from 3-9V is stepped up to 10V using a boost converter (AZ34063U) to get the intermediary voltage rail
- Or if 12V input is required, maybe use 14V or something as the intermediary voltage rail?
MCU controls a FET that charges a cap from that rail via a series resistor to control charge rate
- Divider on the cap feeds into an analog pin on the MCU, once the analog pin reaches the desired level the MCU shuts the FET off again
Once cap is charged, MCU pulses a FET that dumps the charge on the cap through a 1:100 (or so) transformer and to the output
- 0.1-1kV should be achievable via timing the charge FET
May need a dump resistor if the cap is charged and needs to be discharged without zapping?
- Could use the series charging resistor w/ a different FET to dump the cap through it?

All collar output waveforms are through a 1/3 divider, so multiply by 3 to get actual amplitude
Lowest level (1L) seems to be ~90Vpp, highest seems to be ~450Vpp
- I thought the highest was ~2x that? Need to measure the higher ones again to double check

@@ Line 2: / Line 2: @@
 == Project Status ==
+* 2015-03-07: Started putting schematic and BOM together.
 * 2015-02-02: Started putting together overall circuit idea.
 * 2015-02-01: SPICEd out some ideas.