Difference between revisions of "Solder Paste Dispenser"
From Hackstrich
(Waiting for parts now.) |
|||
| (8 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| − | Parts have arrived, | + | * 2013-11: Going to call this done as the new space will have plumbed-in air, and using it with the compressor has been working fine for now. System works great and saves us a lot of time! |
| + | * 2012-03-27: Successfully tested the system! Used the big lab air compressor and dispensed paste for a HeartSpark board successfully. System worked great and saved a huge amount of time. Still need to get the small tank working and find the bezel for the back of the controller box. | ||
| + | * 2012-03-21: Eric sealed the vacuum hose properly, and got a foot pedal connected. Need to bring syringes and misc. parts I have at home next time I'm at the lab to finish this! | ||
| + | * 2011-10-08: Norman has put the new air connector on. I have put a temporary plug into the vacuum connector and tested the unit, it seems to work fine (though currently leaks air out of every connection). | ||
| + | * 2011-07-18: Worked on this with Norman at the lab, he is arranging a new air connector for it, I will sort out what to do about the missing vacuum needle valve. | ||
| + | * Pre-2011: Parts have arrived, new power input module and fuse holder received and need to be installed/tested. Electronics tested and working fine, air circuit not yet tested due to incompatible connectors. | ||
== Goals/Requirements == | == Goals/Requirements == | ||
| Line 13: | Line 18: | ||
* EFD 2000XL dispenser controller | * EFD 2000XL dispenser controller | ||
| − | [[Category: | + | [[Category:Completed Projects]] |
| − | |||
Latest revision as of 19:19, 10 November 2013
The Solder Paste Dispenser project's aim is to assemble a device that can be used to easily apply solder paste to boards using minimal manual effort.
Project Status
- 2013-11: Going to call this done as the new space will have plumbed-in air, and using it with the compressor has been working fine for now. System works great and saves us a lot of time!
- 2012-03-27: Successfully tested the system! Used the big lab air compressor and dispensed paste for a HeartSpark board successfully. System worked great and saved a huge amount of time. Still need to get the small tank working and find the bezel for the back of the controller box.
- 2012-03-21: Eric sealed the vacuum hose properly, and got a foot pedal connected. Need to bring syringes and misc. parts I have at home next time I'm at the lab to finish this!
- 2011-10-08: Norman has put the new air connector on. I have put a temporary plug into the vacuum connector and tested the unit, it seems to work fine (though currently leaks air out of every connection).
- 2011-07-18: Worked on this with Norman at the lab, he is arranging a new air connector for it, I will sort out what to do about the missing vacuum needle valve.
- Pre-2011: Parts have arrived, new power input module and fuse holder received and need to be installed/tested. Electronics tested and working fine, air circuit not yet tested due to incompatible connectors.
Goals/Requirements
- Operate independently of a shop air source
- Dispense using a foot pedal or finger switch
- Have minimal parts so it can be stored in a small bin at the lab
System Plan
- Small (1/4 gallon) air tank, can charge using a schraeder valve from a tire pump
- EFD 2000XL dispenser controller
