Difference between revisions of "LiIon Charger"
From Hackstrich
m (Status-categorizing.) |
(Too much on the go and this isn't a priority at all.) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 10: | Line 10: | ||
* Can either use onboard connectors for USB/battery, or connect to them via the standard headers on the board | * Can either use onboard connectors for USB/battery, or connect to them via the standard headers on the board | ||
| − | [[Category: | + | [[Category:Cancelled Projects]] |
| − | |||
Latest revision as of 23:21, 20 May 2013
The LiIon Charger is a small board which can be powered via USB or through standard headers, and charges a standard single-cell LiIon/LiPoly battery pack.
Project Status
Schematic/board done, BOM on file at Digikey, awaiting sending board to BatchPCB for prototype production.
Design Overview/Ideas
- Based around the LM3658 LiIon charger IC
- Uses an ATtiny25 to communicate via USB and request 500mA from the host (if allowed)
- Using the V-USB stack to keep cost down, no need for a full USB-capable ATwhatever for this
- Can either use onboard connectors for USB/battery, or connect to them via the standard headers on the board
