Difference between revisions of "Arduibug"
From Hackstrich
m (Adding a status category.) |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| − | PCB design complete, initial physical validation looks good. BOM on file at Digikey, boards ordered from @laen. | + | * 2012-12: Newer Arduinos make this much easier (via a solder jumper). Cancelling the project as it's not needed anymore! |
| + | * PCB design complete, initial physical validation looks good. BOM on file at Digikey, boards ordered and received from @laen. Parts ordered and received from Mouser. | ||
| − | [[Category: | + | [[Category:Cancelled Projects]] |
| − | |||
Latest revision as of 04:56, 26 December 2012
The Arduibug is a small adapter board that 'wedges in' between the chip and the socket on the Arduino Diecimila or Duemilanove and allows use of a Debugwire in-circuit-debugger. The normal Arduino board does not allow this due to other components on the /RST line. The board is completely passive, the only components are sockets/headers/switches.
Project Status
- 2012-12: Newer Arduinos make this much easier (via a solder jumper). Cancelling the project as it's not needed anymore!
- PCB design complete, initial physical validation looks good. BOM on file at Digikey, boards ordered and received from @laen. Parts ordered and received from Mouser.
