Difference between revisions of "StrichLux/IO-ETH"
From Hackstrich
(Status update. Schematic done!) |
(PCBs sent off to get made, still need to order parts.) |
||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| + | * 2012-05-27: Routing done, checklist run, CAM processing done, sent off to MyRO for PCB manufacturing. Still need to order parts. | ||
* 2012-05-26: Schematic/BOM complete, routing starting. | * 2012-05-26: Schematic/BOM complete, routing starting. | ||
* 2012-05-25: Started schematic. | * 2012-05-25: Started schematic. | ||
| Line 15: | Line 16: | ||
[[Category:Current Projects]] | [[Category:Current Projects]] | ||
| − | [[Category:Status/ | + | [[Category:Status/Waiting for Time]] |
Revision as of 01:59, 28 May 2012
The StrichLux IO-ETH module will provide 1-4 universes of input or output via Art-Net initially, but may support other protocols later. This module can "take over" adjacent channels if configured to, so that only one module is needed for a complete StrichLux system.
Project Status
- 2012-05-27: Routing done, checklist run, CAM processing done, sent off to MyRO for PCB manufacturing. Still need to order parts.
- 2012-05-26: Schematic/BOM complete, routing starting.
- 2012-05-25: Started schematic.
- 2012-05-01: Renamed from IO-ArtNet to IO-ETH, as I may support ACN or other protocols later.
- 2012-04-24: Started initial planning.
Specs
- Based around the PIC32MX664F128H microcontroller as there is no economical way to do Ethernet on FPGAs for low-cost designs
- This micro has no EEPROM (?!) so will need external I2C EEPROM for storing config data
- Using one with a MAC address burns in solves the problem of needing an IAB too
- Also needs external PHY
- LAN8720C is supported, small, and inexpensive, so it seems a good choice
