StrichLux

The Modular Lighting Controller will control various kinds of lighting via various protocols/interfaces, or convert between two of the supported protocols/interfaces without directly controlling any devices.

Project Ideas

• Core board, lets you plug in up to 4 input modules and 4 output modules
  • Each of the 4 would be up to one DMX universe worth of channels (512)
  • SPI to each I/O module, 8 SPI transceivers total
  • RS232 for troubleshooting and configuring the core board itself
  • Local framebuffer memory
    • Dual-port memory would be best so the output and input sections can both deal with it independently
    • 8 bits per frame * 512 channels per universe * 4 universes = 16kbit (2kbyte) of framebuffer memory required
      • Twice that for double-buffering would be awesome, so 32kbit/4kbyte of dual-port memory wanted
    • Split into 4 channels, so each block would be 8kbit/1kbyte
    • Reading/writing needs to happen in parallel for each block
  • CPLD/FPGA seems a great fit for this
    • Lattice LFXP2-5E-5TN144C or Xilinx XC3S50-4VQG100C both seem like good fits
  • Since this will likely be the most powerful chip in the whole system, we could do transforms here to to take the load off the I/O modules
    • HSV->RGB
    • Input splitting (one input channel goes to two or more output channels)
    • Input combining (two or more input channels get combined via some function and go to a single output channel)
    • Scaling/offsetting (0-255 in = 32-64 out or such)
• Inputs
  • Art-Net over Ethernet
  • Art-Net over WiFi
  • DMX
  • Analog input channels (not 512 though, likely)
• Outputs
  • LPD8806 LED strips
  • Other LED strips
  • Art-Net over Ethernet
  • Art-Net over WiFi
  • DMX
  • Discrete power switches (relays/FETs/whatever)
• Dimensions
  • Core board will be 3.95" x 6.3" (max limits of EAGLE Standard, will need to purchase)
  • Modules will be 1.5" x 1.95" (2x4 layout on the board for input/output x 4 channes)