Difference between revisions of "StrichSwitcher"
From Hackstrich
(Putting up initial page for the strichSwitcher.) |
(There are a bunch of other similar products on the market now, so cancelling this project.) |
||
| (6 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
== Project Status == | == Project Status == | ||
| − | Schematic/board done, | + | Schematic/board done, rev. 1 PCBs received from BatchPCB and parts received from Digikey. Initial order from Digikey shipped resistors instead of caps (330ohm instead of 330pF!), I didn't notice stuffing the board, and something let the magic smoke out (I think the main controller chip). Replacement chip and caps received from Digikey. |
== Design Overview/Ideas == | == Design Overview/Ideas == | ||
| Line 8: | Line 8: | ||
* Buck/boost topology to support battery inputs | * Buck/boost topology to support battery inputs | ||
| − | [[Category: | + | [[Category:Cancelled Projects]] |
Latest revision as of 00:34, 23 January 2012
strichSwitcher is a small integrated switching regulator, designed to take 2.8-7V (i.e. battery inputs from standard AA/C/D cells or LiIon/LiPoly cells) and output 5 or 3.3V.
Project Status
Schematic/board done, rev. 1 PCBs received from BatchPCB and parts received from Digikey. Initial order from Digikey shipped resistors instead of caps (330ohm instead of 330pF!), I didn't notice stuffing the board, and something let the magic smoke out (I think the main controller chip). Replacement chip and caps received from Digikey.
Design Overview/Ideas
- Based around the LTC3534 switching controller
- Buck/boost topology to support battery inputs
